Test-products-international 293 Manual do Utilizador descarregar pdf (Página 22)

f. Measuring Diodes

CAUTION!

Do not attempt to make diode measurements with

circuit energized. The only way to accurately test a

diode is to remove it completely from the circuit before

attempting to measure it.

Instrument set-up:

FUNC. BLACK RED MIN MAX

TEST LEAD TEST LEAD READING READING

COM V/Ω 0.001V 2.000V

Measurement Procedure:

1. Disconnect power to circuit to be measured.

2. Plug the black test lead into COM input jack.

3. Plug red test lead into the V/Ωinput jack.

4. Set the rotary switch to the function.

5. Connect the black test lead to the banded end of

the diode and the red test lead to the non-banded

end of the diode.

6. Reading on the display should be between 0.5 and

0.8 volts.

7. Reverse test lead connections in 5 above.

8. Reading on the display should be OFL (Overload).

NOTE: If diode reads 0 in both directions, diode is

shorted. If diode reads OFL in both directions, diode

is open.

e. Continuity Buzzer

WARNING!

Do not attempt to make continuity measurements with

circuit energized.

Instrument set-up:

FUNC. BLACK RED MIN MAX

TEST LEAD TEST LEAD READING READING

Ω COM V/Ω 0.001KΩ 4.000KΩ

Measurement Procedure:

1. Disconnect power to circuit to be measured.

2. Plug black test lead into the COM input jack.

3. Plug red test lead into V/

ΩΩ

input jack.

4. Set the rotary switch to the

ΩΩ

function.

5. Press the FUNC button until is on the LCD.

6. Connect test leads to circuit to be measured.

7. Listen for the buzzer to confirm continuity.

Optional Modes

• HOLD: Freezes the reading on the LCD.

• TRIM: Push TRIM button to stabalize reading.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comentários a estes Manuais

Sem comentários

Test-products-international 293 Manual do Utilizador Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Test-products-international 293